................................................Return to Harv's Index Page
.....................Previous Page..................................................................Next Page.
.............--- Scatter Shield, Fuel, Exh. and Elect. ---..........
......................
Clutch scatter shield bracket : These (2) little support brackets, one on each side took most of a day to fabricate and install. Only about 300 days to Speedweek.
......................
Front of tail pipe : Decided to run the exhaust out the back into a low pressure area. The exhaust headers are
stock early Saturn. 4 into 2 into 2 1/2" tail pipe. Not sure what that will do to the back pressure but it
should help the aero a little. It would have been a lot easier to run a short exhaust out the side
......................
Mid exhaust support : looking for heavier clamps here. Homemade support.
......................
Rear section of tail pipe : Snake act here with open support at the end.
.....................
Throttle hydraulic slave cyl : Mazda clutch slave cylinder accuating Hayabusa T.B's
....................
Adjustable motion limiter for slave cyl : This is an important item because the hydraulic cylinder will have enough pressure to take out the throttle shaft without something else to limit the stroke.
....................
Battery cut out switch : The switch is well forward so the battery cables will be short.
....................
Control knob for battery disconnect :The black knob (looking for a red one) controls the battery disconnect switch.